![background image](http://html2.mh-extra.com/html/dahua-technology/49925tni/49925tni_quick-start-manual_3216214014.webp)
12
4.3 Mounting the Camera to a Wall
1. Place the PFB305W Wall Mount against the wall and mark the location of the center hole and the
four perimeter mounting holes.
2. Pre-drill the four perimeter holes as marked on the wall for the expansion bolts, using a drill bit
that is no wider than the expansion bolt.
3. Drill a 50-mm (approximately 2 in.) center hole to route the cables, if necessary.
4. Insert an expansion bolt into each pre-drilled perimeter hole, if necessary.
5. Pull the composite cable from the dome through the wall mount and pull it out of the other end of
the wall mount bracket.
6.
Align the flange at the top of the dome with the wall mount, then push the dome into the
bracket.
Then, tighten the M6 screw on the wall mount firmly to the dome.
Note:
Ensure the M6
screw is tightly fixed to secure the dome to the wall mount.
Figure 4-3
7. Use the four (4) hex screws and flat washers to secure the wall mount bracket to the wall.
8.
Make the proper wiring connections and supply power to the camera. Refer to Section 3.2 -
Note:
The video connection is covered by a heat-shrink tube. Once the video connection
is made, gently heat the tube to seal the connection and make it waterproof.