10
Any incorrect use or improper handling of the product shall render the
warranty null and void. Only an authorised technical support service
centre may carry out repairs on the product.
B&B TRENDS SL. disclaims all liability for damages that may occur to
people, animals or objects, for the non-observance of these warnings.
INSTRUCTIONS FOR USE
Prior to connecting the product to the mains, check your power
supply voltage to ensure it is the same as the one indicated on the
label included on the product. Connect the product to the appro-
priate mains. In order to turn on the product, you must select the
slider switch on the control, setting it to position 1, 2 or 3 (Fig.1).
From this time on, the product is operational.
The maximum operation time is 90 minutes, after which the auto-
matic safety shut-down will immediately activate The product will
no longer heat up when in this state.
Select the “ 0” position in order to turn off the product before you
disconnect the device from the mains.
The pad models NC and NCD have been specially designed as
an effective system to relax the muscles of the neck and cervical
vertebrae (NC), as well as the muscles of the upper part of the back
and dorsal vertebrae (NCD) which are the areas most frequently
subjected to muscular tension.
The NC model sits around the rear of the neck, adjusting the velcro
strap ion the textile sleeve, so that it sits approximately under the
chin (Fig. 2). The NCD model is placed at the top of the back just
like the previous model. Its lower section adapts to the waist, and
the snap lock can be adjusted in advance to the required length to
be placed around the navel area. (Fig. 3)
The lumbar-menstrual pad has an ambivalent design especially
adapted for the application of heat in the abdominal area and the
lumbar region. The LM model is positioned by adjusting the product
to the lumbar area using the velcro system (Fig. 4)
TROUBLESHOOTING GUIDE:
Possible operational problems
PROBLEM
RECOMMENDATION
The regulator control does not
light up when the switch is
turned on
Ensure that the regulator is
properly connected to the pro-
duct and that there is voltage
in the socket of the mains used
and that the product is properly
plugged in.
After a certain operation time,
the product temperature seems
to reduce.
The product has an auto-stop
system that activates after 90
minutes of continuous opera-
tion. After this time, the light
on the regulator starts to flash.
If you want to continue to use
it, change the temperature
level to level 0, wait a few
seconds, and then select the
desired temperature.
