DRPB48 Operation Manual
8) Place the
clamping sleeve (#3)
with the
3-jaw set (#4)
inside it onto the
assembly pusher
(#5)
and ensure it is assembled firmly;
9) Replace the front sleeve (#2) and nosepiece (#1) on the tool;
TROUBLE SHOOTING
Problem
Possible Causes
Solutions
Rivet mandrel does not break
3-jaw set worn off or damaged.
Hydraulic oil in tool not sufficient.
Air supply with low pressure.
Change 3-jaw set.
Refill hydraulic oil.
Increase air supply pressure
within the specified range.
Jaws slippery on rivet mandrel
3-jaw set worn out.
Metal chips between jaws.
Pusher spring fatigued.
Change 3-jaw set.
Clean the jaws.
Change pusher spring.
Rivet mandrel cannot be put into
nosepiece
Incorrect nosepiece size chosen.
Jaws get stuck by mandrel not being
released.
Use correct size nosepiece
for rivet.
Remove any jammed
mandrels by disassembling
front sleeve and clamping
sleeve.
Summary of Contents for DRPB48
Page 8: ...DRPB48 Operation Manual ...