EN - 25
7.3
Pump Filter
1
3
5
2
4
6
The pump filter system in your Washing
Machine prolongs the life of the pump
by preventing lint from entering your
machine.
We recommend that you clean the pump
filter every 2 months.
The pump filter is located behind the
cover on the front-lower right corner.
To clean the pump filter:
1.
You may use the supplied with your
machine or liquid detergent level plate
to open the pump cover.
2.
Lodge the end of the liquid detergent
level plate in the opening of the cover
and gently press backwards. The
cover will open.
•
Before opening the filter cover, place
a container under the filter cover to
collect any water left in the machine.
•
Loosen the filter by turning
anticlockwise and remove by pulling.
Wait for the water to drain.
NOTE:
Depending on the
amount of water inside the machine, you
may have to empty the water collection
container a few times.
3.
Remove any foreign materials from
the filter with a soft brush.
4.
After cleaning, re-fit the filter by
inserting it and turning clockwise.
5.
When closing the pump cover, ensure
that the mountings inside the cover
meet the holes on the front panel side.
6.
Close the filter cover.
WARNING:
The water in
the pump may be hot, wait until it has
cooled down before carrying out any
cleaning or maintenance.
7.4 Detergent Drawer
The use of detergent may cause residual
build up in the detergent drawer over
time. We recommend that you remove
the drawer every 2 months to clean the
accumulated residue.
To remove the detergent drawer:
•
Pull the drawer forwards until it is fully
extended.
• Press the region shown below inside
the detergent drawer you have pulled
all the way back, and continue pulling
and remove the detergent drawer from
its place
• Remove the detergent drawer and
disassemble the flush stopper. Clean
thoroughly to completely remove
any softener residue. Refit the flush
stopper after cleaning and check that
it is seated properly.
