6
Tornado Cylinder 700W Cyclonic Vacuum
FLR00046
User Manual
IMPORTANT
–
RETAIN THESE INSTRUCTIONS FOR FUTURE REFERENCE
5.
Remove the Hepa (a) and the foam (b)
filter (arrowed right). Wash the filters in
running water until the water runs clear.
Allow the filters to dry for 24 hours
before reuse.
6.
Lift the
Cyclonic filter
(19) out of the
Dust compartment
(9) and again wash in
running water until clean. Allow the filter
to dry for 24 hours before reuse.
6
1.
Once the dust level reaches the ‘MAX’
mark (arrowed left) on the
Dust
compartment
(9) it will need emptying
and the filters cleaned.
2.
To empty the cleaner, press the
Cylinder
release button
(6) and remove the
cylinder.
3.
Hold the
Dust compartment
(10) over a
dust bin and pull the
Dust release catch
(20) outwards slightly to open and allow
the dust to fall out of the into the bin.
4.
Next twist off the
Filter cover
(18) by
rotating it anticlockwise and remove.
a
b
Using the power/speed controller (4)
This control is useful for varying the suction power. Rotate the control downwards to reduce
power whilst cleaning hard floors or similar and rotate upwards to increase suction power for
carpets, rugs, etc.
Emptying and Cleaning Your Vacuum Cleaner
WARNING
Always disconnect the cleaner from the mains power supply before cleaning.
1
2
3
4
5
WARNING
do not continue to use your
vacuum cleaner once the ‘MAX’ mark
has been reached as permanent
damage may occur to the appliance.
