Daewoo KUF-150Q, Service Manual

Page: 42 / 47

3. PCB error displays
41
ELECTRIC CIRCUIT
E ER RR RO OR R
C Co on ntte en nttss
d diissp plla ayye ed d
Drain error. Check the location of the drain hose, drain synchronous motor, and
bellows.
Open/close the door and press “Start/Pause”to run the washer again.
Drain error. Check if the tap is left open, water temperature is correctly
selected, the hose is properly connected, or impurities are collected in the
water-supply valve.
Or the water-level sensor error.
Open/close the door and press “Start/Pause”to run the washer again.
The laundry tangled during spin-drying or 수평량 and safety switch error.
Adjust the levelness or correct the safety switch contact.
Open/close the door and press “Start/Pause”to run the washer again.
The door opened during washing/spinning/or timing.
Replace the door switch and safety switch in case the error exists after the door
is closed.
Open/close the door and press “Start/Pause”to run the washer again.
Load sensing error.
Replace PCB ASS’Y in case the error is indicated for 0.5 sec after load sensing
operates for 7 sec and the level is always set to “High”.
Water level sensing error.
Check the water-level sensor and the connector of the water level sensor Ass’
y in the back.