11
(1) To reduce gap located on part ‘A’
• Loosen two screws on the stopper hinge top, and then
push the door to contact the door seal to the oven front
surface.
• Tighten two screws.
(2) To reduce gap located on part ‘B’
• Loosen two screws on the stopper hinge under, and then
push the door to contact the door seal to the oven front
surface.
• Tighten two screws.
4. Method to reduce the gap between the door seal and the oven front surface.
NOTE :A small gap may be acceptable if the microwave leakage does not exceed 4mW/cm
2
.
