6
Plug power supply cord into 230V AC 50Hz power
outlet.
After placing the food in a suitable container, open
the oven door and put it on the glass tray. The
glass tray and roller guide must always be in place
during cooking.
Close the door. Make sure that it is firmly closed.
The oven door can be opened at any time during
operation by pulling the door. The oven will
automatically shut off. To restart the oven, close
the door and then push the START button.
The oven automatically cooks on full power unless
set to a lower power level.
The display will show “ : 0” when the oven is
plugged in.
Time clock returns to the present time when the
cooking time ends.
When the STOP/CLEAR button is pushed during
the oven operation, the oven stops cooking and all
information retained. To erase all information
(except the present time), push the STOP/CLEAR
button once more. If the oven door is opened
during the oven operation, all information is
retained.
If the START button is pushed and the oven does
not operate, check the area between the door and
door seal for obstructions and make sure the door
is closed securely. The oven will not start cooking
until the door is completely closed or the program
has been reset.
NOTE : When using the GRILL or COMBI mode;
• Do not open the door so often, the temperature
inside the oven decrease and the cooking may
not be completed in setting time.
• Never touch the oven window and metal interior of
the oven when taking food in and out, because
the temperature inside the oven and door is very
high.
• When using these modes, be careful as the tray
will be hot to touch, use oven gloves or pot
holders while handling tray.
OPERATION PROCEDURE
This section includes useful information about oven operation.
1
2
3
4
5
6
7
8
9
10
once
P-HI
100%
twice
P-90
90%
3 times
P-80
80%
4 times
P-70
70%
5 times
P-60
60%
6 times
P-50
50%
7 times
P-40
40%
8 times
P-30
30%
9 times
P-20
20%
10 times
P-10
10%
11 times
P-00
0%
Make sure the oven is properly installed
and plugged into the electrical outlet.
WATTAGE OUTPUT CHART
•
The power-level is set by pushing the Micro Power button. The chart shows the display, the power level
and the percentage of power.
Push the Power button
Power level (Display)
Approximate Percentage of Power