Daewoo KOG-366T0S, Service Manual, Page: 29 / 56

28
(1) Remove the gasket door(A07) from door painting ass’y (A05)
(2) Remove the door frame(A01) from door painting ass’y (A05)
(3) Remove the barrier screen outer(A02) and the supporter barrier screen outer(A03).
(4) Remove the hook spring (A09) and the hook (A08).
(5) Remove the hinge stopper top ass’y(A04).
(6) Remove two screws(A11) which secure the handle door(A10).
(7) Remove the handle door(A10) from the door frame(A01).
(8) Reverse the above steps for reassembly.
4. Method to reduce the gap between the door seal and
the oven front surface.
(1) To reduce gap located on part ‘A’
1) Loosen two screws on the top hinge stopper, and
then push the door to contact the door seal to oven
front surface.
2) Tighten two screws.
(2) To reduce gap located on part ‘B’.
1) Loosen two screws in under hinge stopper, and then the door to contact the door seal to oven front
surface.
2) Tighten two screws.
(3) To reduce gap located on part ‘C’. (See Fig. A)
1) Loosen a screw on the interlock switch assembly located at the bottom of the oven body.
2) Draw the interlock switch assembly inward as possible with hook on the door bottom.
3) Tighten a screw.
(4) To reduce gap located on part ‘D’. (See Fig. B)
1) Loosen a screw on the interlock switch assembly located at the top of the oven body.
2) Follow step (3) 2) and 3).
NOTE:
A small gap may be acceptable if the microwave leakage does not exceed 4m W/cm
2
.