10
(1) Remove the gasket door from door plate.
(2) Remove a screw from door plate.
(3) Remove the door frame from door plate.
(4) Remove the stopper hinge top from door plate.
(5) Remove the spring and the hook.
(6) Remove two screws from door frame.
(7) Remove the handle door and barrier screen outer from door frame.
(8) Remove the barrier screen outer from handle door.
(9) Reverse the above steps for reassembly.
4. Method to reduce the gap between the door seal and the
oven front surface.
(1) To reduce gap located on part ‘A’.
• Loosen two screws on stopper hinge top, and then push the door
to contact the door seal to oven front surface.
• Tighten two screws.
(2) To reduce gap located on part ‘B’.
• Loosen two screws on stopper hinge under, and then push the
door to contact the door seal to oven front surface.
• Tighten two screws.
NOTE : A small gap may be acceptable if the microwave leakage does not exceed 4mW does not exceed 4mW/cm
2
.
