8
Flat Fan Heater
Model No. HEA1927
User Manual
IMPORTANT – RETAIN THESE INSTRUCTIONS FOR FUTURE REFERENCE
Hint on setting the Correct Temperature
•
Set the heater to the desired heat setting as above.
•
Rotate the
Thermostat Control
(2) to the maximum position and allow the
room to warm up. Once the desired room temperature has been reached turn
the
Thermostat Control
(2) anticlockwise until the heater just clicks off then
turn it back up clockwise very slightly. The
Thermostat Control
(2) will now
maintain the room temperature, if necessary, further increasing or decreasing
the
Thermostat Control
(2) may be required to ‘fine tune’ the ideal room
temperature.
•
Return the
On/Off/Fan/Heat Switch
(4) to the
(
O
) position to switch off the
heater.
Fan Only Mode
•
Rotate the
On/Off/Fan/Heat Switch
(4) to the fan only position ( ) to enable
the fan to operate for cool air output.
The
Thermostat Control
(2) will need to be rotated to the fully clockwise
position for the fan to operate.
Care and Use of Your Fan Heater
•
Always disconnect the heater from the mains power supply and allow to cool
before cleaning.
•
Clean outside of the heater with a clean damp cloth. Never clean with harsh or
abrasive cleaners.
•
DO NOT
submerge any part of the heater in water or any other liquids.
•
DO NOT WRAP THE MAINS CABLE AROUND THE APPLIANCE.
Safety Cut – Out
This appliance is fitted with a built in safety cut-out, if the cut-out
is activated the unit stops working, unplug the heater from the mains and check
that the air intake area is not blocked or covered.
Leave for an hour to cool and reset before plugging back into the mains.
Technical Specification
Rated Voltage
220-240V~ 50Hz
Rated Power
1800-2000W
Model Number
HEA1927
Dimensions
245mm (H) x 240mm (W) x 120mm (H)
Weight
1.1kg
Protection Class
II
WARNING!