9
IMPORTANT
–
RETAIN THESE INSTRUCTIONS FOR FUTURE REFERENCE
White Convector Heater with Turbo, Timer & LCD
Model No. HEA1812
User Manual
Operating Instructions
–
the heat settings
1.
Place the heater upright on its feet (9) on a solid, level, non-flammable surface.
2.
Insert the mains plug into the mains socket.
3.
Press the
Mains Switch
(7) to the ON position (I). The switch will illuminate to
indicate the power is on and the
LCD Display
(3) will show the current room
temperature on the
Room Temperature
display (24).
4.
Press the
On/Off Standby
button (19) on the
Control Panel
(2), the control
panel will illuminate and display the
Room Temperature
(24) and
Set
Temperature
(25).
Setting the Temperature
1.
With the display showing the room temperature and the set temperature
as above, use the
Increase Temperature
+ (21) and the
Decrease
Temperature
–
(22) buttons to set the desired temperature on the
Set
Temperature
(25) display.
2.
Press the
Power Level
button (16), to select the heating power level required,
(1000W, 1300W or 2300W
–
as shown on the
Heat Level Mode
(12) on the LCD
Display (3)).
3.
The heater will now start to heat the room at the set temperature.
The set temperature range is 5-
37⁰C, (41
-
99⁰F)
.
Press the
⁰F or ⁰C
Button (17) to change the display between degrees
Centigrade or degrees Fahrenheit.
Using the Timer
This heater has a built in timer which switches the heater
off
after a maximum
time of 24 hours. Set the timer as follows:
1.
First, s
et the heat settings up as above in ‘
Setting the Temperature
’
before
setting the timer.
2.
Press the
Timer
button (23) once and the
Timer Display
(26) will flash.
3.
Repeatedly press or hold down the
Timer
button (23) to select the desired
time (in hours) before the heater switches off is shown on the
Timer Display
(26).
4.
The timer will count down and then switch off the heater once the time has
elapsed.
Press the
On/Off Standby
button (19) to switch the heater back on
again if required.
Cancelling the Timer
1.
Repeatedly press the
Timer
button (23) until the time shows 24 hours on the
Timer Display
(26).
2.
Press the
Timer
button (23) once more and the
Timer Display
(26) will go out
showing that the timer is now cancelled. Press the
Timer
button (23) again to
enable the timer again if required.
