17
How to install Water Line
(Dispenser modes only)
The water pressure should be 2.0~12.5 kgf/cm² (1.96
1.
~12.26 Bar) or more to run the automatic icemaker.
Check your tap water pressure; if a cup of 180cc is
✽
full within 10 seconds, the pressure is OK.
When installing the water tubes, ensure they are not
2.
close to any hot surfaces.
The water filter only filters water; it does not eliminate
3.
any bacteria or microbes.
If the water pressure is not sufficient to run the
4.
icemaker, call the local plumber to get an additional
water pressure pump.
The filter life depends on the amount of use. We
5.
recommend you to replace the filter at least once
every 6 months.
When attaching the filter, place it for easy access
✽
(removing & replacing)
After installation of refrigerator and water line system,
6.
select [WATER] on your control panel and press it for
2~3 minutes to supply water into the water tank and
dispense water.
Use plumbers thread sealing tape on every
7.
connection of pipes/tubes to ensure there is no water
leaks.
The water tube should be connected to the cold water
8.
line.
WATER SUPPLY KIT
■
Check the parts below for installing water supply.
✽
Some other necessary parts are available at your
local service agents.
Connector
Filter box
Water tube
Installation Procedure
(Dispenser
models only)
1. Join Connector to the tap water line
Figure A
Water tube
Connector A
Connector B
Tap
Rubber packing
Figure B
Water tube
Connector A
Tap
Rubber packing
Place the rubber packing inside the tap connector
and screw onto the water tap.
2. Connect the Water Tube to the refrigerator.
1) Remove the rear cover at the bottom back of the
refrigerator.
2) Insert the fastening ring into the Water tube. (Be
careful to follow the direction of the nut.)
3) Insert the Water Tube into the top of the water valve,
turn the nut clockwise to fasten it. (The water valve is
to the right of the motors.)
4) Check for any bent tubes or water leaks; if so,
recheck installation procedure.
5) Replace the rear cover. (The water tube should be
placed between the groove of the refrigerator back
and motor cover.)
Water tube
Water tube
Water valve
Nut
Set the tube upright as the figure shows.
