20
20
Leave a sufficient distance when cutting the tubes.
2. Get ready to install the Water Filter
1) Measure an approximate distance between the filter and the Water
Tube and cut the tube off filter vertically.
2) Connect the tubes to the filter as the figure shows.
How to install Water Line
(Dispenser Models Only)
WATER SUPPLY KIT
1. The water pressure should be 2.0~12.5kgf/cm
2
or more to run the
automatic icemaker.
Checkup your tap water pressure ; if a cup of 180cc is full within
10 seconds, the pressure is OK.
2. When installing the water tubes, ensure they are not close to any
hot surfaces.
3. The water filter only filters water ; it does not eliminate any
bacteria or microbes.
4. If the water pressure is not so high to run the icemaker, call the
local plumber to get an additional water pressure pump.
5. The filter life depends on the amount of use. We recommend you
replace the filter at least once every 6months.
When attaching the filter, place it for easy access (removing &
replacing)
6. After installation of refrigerator and water line system, select
[WATER] on your control panel and press it for 2~3 minutes to
supply water into the water tank and dispense water.
7. Use sealing tape to every connection of pipes/tubes to ensure
there is no water leak.
8. The water tube should be connected to the cold water line.
Check the parts below for installing water supply.
Some other necessary parts are available at your
local service agents.
Installation Procedure
(Dispenser Models Only)
1. Join Connector to the tap water line
3011202000
(3019974100)
(A:3019503200
B:3019503300)
(3012020700)
(7112401211)
Connector
(3014454520)
Place the rubber washer inside the tap connector and screw onto the water tap.
<Figure A>
<Figure B>
