background image

4

Cleaners:

The cleaners noted below are available. Never use harsh, abrasive cleaners, heavy-

duty cleaners, or solvents on any surface.

Exterior:

Wipe with damp, sudsy cloth, rinse and dry. For stubborn stains and for periodic

waxing, use silicon wax.

Evaporator:

When refrigerator needs defrosting turn thermostat dial to “OFF”. Do not use sharp

instruments.

Refrigeration Section:

Wash shelves and other removable parts in warm sudsy water, rinse and

dry. Wash interior with baking soda solution (3 table spoons to one quart of water) or warm
sudsy water, rinse and dry.

Magnetic Door Seals:

Wash with warm sudsy water.

The Finishing Touch:

Replace all parts and return thermostat dial to desired setting.

Install refrigerator in a convenient location away from extreme heat and cold. Allow
sufficient clearance between the refrigerator and side wall so the door will open for a fully
usable interior. Refrigerator is not designed for recessed installation.

Select a place with strong level floor.

Allow 5 inches of space between the 
refrigerator’s side and the wall.

HOW TO CLEAN

HOW TO INSTALL

5
inches

3

HOW TO OPERATE

1. Clean the refrigerator thoroughly. Wipe the outside with a soft dry cloth, the inside with a

damp cloth.

2. Keep the door open and insert the power supply cord into the socket.

3. Turn the thermostat dial to “7”. Close the door and let the refrigerator operate for 15-20

minutes.
The freezer should then show some traces of frost.

You can control the inside temperature by turning
the thermostat dial. Higher numbers mean greater
cooling power, smaller numbers mean less cooling
power. To make ice cubes in the freezer
compartment, set the dial to “7”. The dial does not
have to be set exactly on the numbers, but can be
any place in between.

Defrost the refrigerator when the frost accumulated on the evaporator is about 5mm(1/5inch)
thick.
Set the thermostat dial to “OFF”. Remove foods. Keep drip tray in place. Defrosting usually takes a
few hours. To defrost quickly remove all foods from the refrigerator and leave door open. Never
use a knife or other metal instrument to remove ice/frost from the evaporator. After defrosting
empty water from drip tray, return the thermostat dial to the desired position to start refrigerating
again.

6

7

5

4

3

2

1

OFF

CO

LD

E

R

TEMPERATURE
CONTROL

NOTE :

Wait 3 to 5 minutes before restarting if you unplug the machine. Unit may
fail to operate properly if restarted too quickly.

Temperature control

Starting your new Refrigerator

How to defrost

Summary of Contents for FR-A053D

Page 1: ... controls the inside temperature of the refrigerator 4 SHELF Has full width and can slide out 5 RACK For butter eggs and small size goods 6 MAGNETICDOORSEALS Keeps the refrigerator virtually airtight all along the edge but is nevertheless easy to open 7 ICE CUBE TRAY Ice cubes are easy to remove from the tray 8 USABLE RACK for cans or jars 9 BOTTLE RACK for bottles cans or jars 10 CRISPER for vege...

Page 2: ...ghly Wipe the outside with a soft dry cloth the inside with a damp cloth 2 Keep the door open and insert the power supply cord into the socket 3 Turn the thermostat dial to 7 Close the door and let the refrigerator operate for 15 20 minutes The freezer should then show some traces of frost You can control the inside temperature by turning the thermostat dial Higher numbers mean greater cooling pow...

Page 3: ...rd is damaged it must be replaced by the manufacturer or its service agent or a simmilary qualified person in order to avoid a hazard This refrigerator has been built with the door hinges on the right If you wish to change the opening direction follow the instruction below Unplug the refrigerator from its electrical outlet Empty everything in the refrigerator including shelves food etc 1 Remove th...

Page 4: ...o screws previously removed in step 6 NOTE Do not tighten screws 8 Stand the cabinet 9 Replace the door making sure the bottom socket enters the bottom hinge pin Be sure washer is in place 10 While holding the door in the closed position secure the top hinge at the left side using the two screws previously removed at the beginning in step 2 Do not tighten the screws until the top of the door is le...

Reviews: