METHODS OF SAFE INSTALLATION
1. SAFE INSTALLATION PLACE FOR YOUR REFRIGERATOR
4
•
Place the refrigerator on
hard and level floor.
NO
NO
•
Place your refrigerator
where there is no heat
source nearby.
High surrounding
temperature will lower
cooling efficiency and
increases your electricity
bill.
•
Place the refrigerator in
an area with low
moisture.
Splashing water or a
high moisture area may
cause a short circuit and
make rusting easier.
•
Avoid places that are
exposed to smoke.
The discoloring can
occur to the refrigerator.
At least 15cm
At least 15cm
At least 30cm
Carpet
Wooden Board,
Rubber Mat
•
For good ventilation
place refrigerator with
the space specified on
the figure.
This helps cooling
efficiency and lowers the
electricity bill.
•
Placing the refrigerator
on the carpet may cause
heat to develop and
discolor the appliance. In
such a case put a hard
wooden board or a
rubber mat between the
refrigerator and the
carpet.
HOW TO OPERATE
1. TEMPERATURE CONTROL
3
OPERATING YOUR REFRIGERATOR
* Setting the Temperature Control
• To control the internal temperature, adjust the control dial according to the ambient
temperature or purpose of use.
• The first time you turn the unit on, set the temperature control to “MAX”.
• The range of the temperature control is from position “MIN” the warmest to “MAX”
the coldest. After 24 to 48 hours, adjust the temperature control to the setting that
best suits your needs. The setting of “MED” should be correct for home or office
refrigerator use.
• If the unit is unplugged, power lost, or turned off; you must wait 3 to 5 minutes
before restarting the unit. If you attempt to restart before this time delay, the
refrigerator will not start.
Freezer Temperature Control
Refrigerator Temperature Control
MAX
MED
MIN
TEMP. CONTROL
MAX
MED
MIN
TEMP. CONTROL
MIN
When ambient Temp. is below 15˚C or 59 ˚F
MED
When ambient Temp. is between 15-25˚C or 59-77˚F
MAX
When ambient Temp. is above 25˚C or 77˚F
