4
Te m p e r a t u re is controlled by thermostat automatically. The Te m p e r a t u re Control inside the
refrigerator controls the degree of cooling for each compart m e n t .
The control has four settings from MIN to
WINTER. The WINTER mode is available only if
atmosphere temperature is below 10°C
The control has the four settings from MIN to
WINTER. The WINTER mode is available only if
atmosphere temperature is below 10°C
1. TEMPERATURE CONTROL
To turn off the re f r i g e r a t o r
N O T E :
During spells of hot, humid weather and in rainy season, moisture
may develop on the cabinet, just as water condenses around a cold
glass of water. It is not an abnormal condition; wipe off the moisture
with a dry cloth. This can also happen when the refrigerator is not
installed in an appropriate place.
1. Clean the refrigerator thoro u g h l y. Wipe the outside with a dry cloth, and the inside with
a damp cloth.
2. Set the temperature control knob at normal position.
3. Connect the power supply cord .
Disconnect the power supply cord. Remove icing case and food. Leave doors ajar for
ventilation and dehumidification of both compartments.
F reezer Te m p e r a t u re Contro l
Refrigerator Te m p e r a t u re Contro l
With the Refrigerating System in operation, it is likely that the cabinet will feel warm at the fro n t
edges and sides. This does not indicate tro u b l e .
It is due to the hot-line used in this type of Refrigerating System which consists of piping hot gas
f rom the (motor-driven) compressor along the front edges, the sides of the cabinet and the center
p a rtition to prevent dewing. This has nothing to do with the storage temperature inside.
(The thick line indicates the hot-line)
2. RADIANT HEAT
HOW TO OPERAT E
TEMP. CONTROL
TEMP. CONTROL
Starting your new refrigerator
3
CAUTION:
1. Check your voltage before inserting the power supply cord into the socket.
2. Contact the earthing conductor to this unit with an attachment earthing screw.
3. Do not spill liquid on this unit.
4. Do not use flammable spray, such as painting, near this unit.
5. Do not place ignitable material, such as benzine, L.P. gas, alcohol etc., into this unit.
6. Take precautions against leakage of any gas equipment near this unit.
7. Keep chidren from hanging on the door of this unit.
8. Do not reinsert the power supply cord within 5 minutes after releasing it from the
socket. If not, there may be problems with the compressor.
9. Put food in the refrigerator after running the refrigerator for 2~3 hours.
Take a moment to know all the features designed for the convenience of the user.
■
Ice tray
Fill 3/4 of the ice tray with water, as the volume expands when the water is frozen. Place
the tray in the freezer compartment. To release ice cubes, twist the ice tray slightly. Ice
cubes will be easier to remove if it is held for a short while under running water.
■
Movable refrigerator and freezer shelves
Storage shelves should be adjusted depending on the height of the food stored. To do this,
pull the shelves slightly forw a rd .
■
D e f rost-drain Ve s s e l
Since dust accumulated on the drain case decreases the evaporation eff i c i e n c y, you
should clean the drain case at regular interv a l s .
■
Vegetable case
May be used for fruit and vegetable storage. Both the vegetable case and its cover shelf
a re removable for easy cleaning. Simply slide forw a rd to re m o v e .
■
Utility Pocket (To p )
The Egg Case in this pocket can be turned upside down for the use of small size goods.
Location
Install the refrigerator in a convenient location away from extreme heat and cold. Allow
at least 6cm clearance between the refrigerator and side wall so that the door may open
for a fully usable interior and the refrigerator may have good air circulation. The
refrigerator is not designed for recessed installation.
■
Select a strong and level floor.
■
Keep 6cm of space between the refrigerator and the walls.
Here are the features of your new refrigerator.
HOW TO INSTA L L
