2
2.
INSTALLTION
2.1
Location
When selecting a position for your unit you should make sure the floor is flat and firm, and the
room is well ventilated with an average room temperature of between 16
℃
and 38
℃
. Avoid
locating your unit near a heat source, e.g. cooker, boiler or radiator. Also avoid direct sunlight as it
may increase the electrical consumption. Extreme cold ambient temperatures may also cause the
unit not to perform properly. This unit is not designed for use in a garage or outdoor installation.
Do not drape the unit with any covering.
When installing the unit, ensure that 40 cm of free space is left at both sides, 15 cm at the rear
and 20 cm at the top of the unit. This will allow cold air to circulate around the wine cooler and
improve the efficiency of the cooling process. The door can be opened to the right or the left,
depending on what better suits the location. Please ensure there is adequate space for the door
to fully open.
2.2
Reversing the Door Swing
Tools Required:
Phillips style screwdriver / Flat blated screwdriver / Hexagonal spanner
◆
If you want to have the door swing reversed, we recommend that you contact a
qualified technician. You should only try to reverse the door yourself if you believe that
you are qualified to do so.
◆
Ensure the unit is unplugged and empty.
◆
Adjust the two levelling feet to their highest position.
◆
To take the door of it is necessary to tilt the unit backwards. You should rest the unit on
something solid so that it will not slip during the door reversing process.
◆
All parts removed must be saved to do the reinstallation of the door.
◆
Do not lay the unit fat as this may damage the coolant system.
◆
We recommend that 2 people handle the unit during assembly.
1)
Start by removing the bracket from the bottom of the
refrigerator.Unscrew the two screws from the bottom
bracket.Remove the foot from opposite side.
2)
Self-Tapping Screws/Bottom Bracket/Foot
