17
How to handle the washing machine
Questions
How to clean the water supply net
••• If the water does not come out smoothly, some alien
substances might be in it (sand, stones, soil, rust). In
this case, remove the net and clean it.
••• If you use underground water, in case of post monsoon
seasons, newly built apartment, recent cleaning of the
water tank or old water pipes, clean it frequently
because there will be a lot of waste in the water.
• By using a tool (clamp) or hand, remove the net from the
top of the water supply hole. (Both hot/cold water)
• Soak the net in water, brush it off and rinse it.
• Insert the net in the water supply hole again.
Connect your water supply hose, power cord and faucet
and operate the washing machine and check the
condition.
Cleaning the magic filter
1. Press down the top of the filter and pull it toward you.
Open the cap.
2. Remove fluff and dust.
3. Rinse with water.
4. Insert the magic filter starting from the bottom to the
top.
How to avoid freezing
• Close the water faucet and remove the water from the
hose completely.
• Discharge the water from the washing tank and the drain
hose for one minute so that there is no water left inside.
• Take out the power plug.
» In case of freezing, pour hot water on the faucet to take
out the water supply hose.
• Fill the washing tank with hot water and leave it for a
while.
• Soak the water supply hose in hot water.
• After connecting the water hose, check the water supply/
drainage is completed correctly.
I hear some strange sounds!
• When the washing tank stops spinning, I hear ‘shaaa’
sounds.
This is normal. It is because the levelness is maintained
after spinning operation.
• I hear ‘winnnnngg’ sounds, during water supply.
This indicates normal operation of the water supply
valve.
This is normal. It is the sound made when the air
bubbles are generated.
My washing machine is acting strangely!
• During spin drying, it suddenly goes into rinsing mode
and the remaining time is increased.
This is because the laundry is tilted towards a certain
side, and excessive vibrations occur. Action is taken to
evenly spread out the laundry. If it fails two times in a
row, the error display (
UE
) will be shown and a sound
will be heard. In this case, spread out the laundry evenly,
close the cap and press the start button.
• During washing, more stains are left on the laundry.
The leftover soap from hand washing remains in the
washing tank to cause this type of pollution as it falls
onto the laundry during water supply. Clean the washing
tank thoroughly. For cleaning supplies, contact the
service center.
• After the first rinsing and draining, spin drying is weak.
There is too much laundry or detergent which can cause
excessive bubbles. Use only an adequate amount of
detergent.
• The motor operates although I did not add water.
Before water supply, the motor will operate for about five
seconds to detect the amount of laundry.
DWF-G300'S(영)_요르단.indd 17
2017. 6. 12. 오후 4:33
