Daewoo DWF-805M, Service Manual, Page: 6 / 25

5 CONNECTION
FOR ORDINARY TAP
6
Connect the inlet hose adapter
of the hose to the water inlet of
the washer by turning it clock-
wise to be fixed tightly.
• Please check the rubber packing
inside the inlet hose adapter of
the hose.
1
Pull down the collar
of the inlet hose to
separate it from the
water tap adapter.
2
Loosen the four
screws at the water
tap adapter, but don’t
loosen the screws until
they are separated from
the water tap adapter.
4
Remove the tape,
and screw connector
B into connect A tightly.
5
Connect the inlet
hose to the water tap
adapter by puling down
3
Connect the water tap
adapter to the water tap tight-
en the four screws evenly
while pushing up the adapter
so that the rubber packing
can stick to the water tap
tightly.
§ HOW TO CONNECT THE INLET HOSE
Be careful not to mistake in supplying between the hot(maximum : 50˚C) and cold water.
In using only one water tap or in case of attached one water inlet valve, connect the inlet hose to the cold water inlet
valve.
Do not over tighten : this could cause damage to couplings.
FOR SCREW-SHAPED TAP
3
Insert the inlet hose adapter
into the water inlet of a washer
and turn it to be fixed.
• Assert the packing in the inlet
1
Connect the inlet
hose to the water tap
by screwing the con-
nector D tightly.
2
Connect the connec-
tor-inlet supplied if
necessary.
Inlet Hose
Connector D
Rubber
Packing
Connector C
Connector
Inlet
Rubber
Packing
Connector D
Connector C
Hose
WAS H
SPR AY
RIN SE
RIN
SE SPIN
FUZZ Y BLAN
KET ECO
NOM Y
SUIT
DETER
GEN T
SOA K
CONTR
OL ONLY
SPIN
WATER
LEV EL
RES
.
COU
RSE
PROCE
SS STA
RT HO LD
POW ER
WAS H TEM
P.
HO
T CO
LD
HIG H
MEDIU M LOW
SMA
LL
RES .
REM
AIN
MIN.
DW F-1
74 W
TAPE
Connector B
Connector A