17
TROUBLE SHOOTING GUIDES
Most problems are easily solved if you understand the cause. Check the following list for
problem before calling for service.
Before calling for service, check these
NOTES:
Please check the point before calling for a service.
If the supply cord is damaged, it must only be replaced by a repair shop appointed by manufacturer, because
special purpose tools are required.
• The washer will not operate at all.
• Water is not supplied;
If water supply is not finished within 30 minutes,
the lamp
will light up, and the buzzer will
sound to indicate a problem.
• The washer will not drain;
If the drain is not finished within selected time, lamp
will light up, and the buzzer will sound to
indicate a problem.
• The washer will not spin;
If the clothes is collected on one side during spin and
the tub becomes unbalanced, the spin operation will
be interrupted, and then this unbalanced condition
will be corrected by following operation; WATER
SUPPLY
➡
➡
Rinse
➡
➡
Drain However if the
unbalanced condition is unchanged despite repeating
the above operation, the lamp
will light up, and
the buzzer will sound to indicate a problem.
• Is there a power failure?
• Is the power cord correctly connected to an
electric outlet?
• Is the electric fuse broken?
• Did you turn on the power?
• Did you press Start/Hold button?
• Is there correct amount of water in the tub?
• Did you connect the inlet hose and open the
water tap?
• Is the inlet hose or the water tap frozen?
• Is the water supply shut off?
• Does foreign matter block up the inlet hose
filter?
• Is the drain hose frozen or blocked up by dirt?
• Is the drain hose kinked or deformed?
• Is the end of the drain hose immersed in
water?
• Is there excessive dirt inside the pump
housing?
• Is the clothe in the tub collected on one side?
• Is the washing machine installed on an uneven
floor or is the vibration serious?
• Is the lid open?
(the lamp
will light up in this case.)
PROBLEM
CHECK POINT
• These cases are not malfunctions
• The sound “Wing” heard during water supply is the operating sound made by the water inlet valve.
• The sound “sha” heard in stopping the tub is the sound that comes from the autobalancer of the
tub.
• The sound “Wung” heard during washer or spin is the operating sound made by the air bubble
generator.
DWF-800MP(¿ )
01.3.26
9:58
PM
˘
`
17