Daewoo DWF-1095 E Series, Manual, Page: 11 / 37

19 20
HOW TO CLEAN DRAIN FILTER (ONLY Px MODEL)
In this washer, the drain filter is equipped at the back side of it.
This drain filter is to screen the foreign stuffs such as threads, coins, pins, buttons etc...
And this should be cleaned frequently(every 5 times of use) for its smooth operation.
Drain problem could be caused if the drain filter is not cleaned at proper time.
Please Keep it clean.
Incase you clean the drain filter, please follow the instructions as below.
NOTES
During the operation, the “OE” signal means drain error can displayed on the control panel.
In this case, the main cause of that problem is the blocking of the drain filter.
If you clean the drain filter following above instructions, you could continue the normal operation of this
washing machine to rest the program please turn the power off and on again.
1 1
Remove the remained
water
• Put down the remained water in the
hose. And put a container under the
filter to collect water.
2 2
Unscrew the cap.
• Turn the cap counter clockwise.
3 3
Release the filter
assembly.
• Pull out the filter assembly off the case
of the main body.
4 4
Remove the foreign
stuffs.
•
Clean the drain filter removing the
foreign stuffs.
5 5
Put the filter assembly
back.
• Put the filter along the guiding
prominence of the case. Please note
the left position of the filter adjusting
the groove to the guide rib.
6 6
Lock the cap.
• Turn the cap clockwise tightly.
CONTAINER
FITER
CAP
FILTER
CAP
CASE
CAP
CAP
SLIT
GUIDE RIB
CASE
FILTER
CAP
FILTER
HOW TO INSTALL THE DRAIN HOSE (ONLY Px MODEL)
INSTALLATION OF THE DRAIN HOSE
Never forget to install drain hose before operating this washing machine.
There are a drain hose, a hose clamp, a hose fixture and a hose guide in the washing machine.
NOTES
1. Keep the drain hose fixed tightly in the hose fixture, or let the highst point of the drain hose be more
than 1m above the floor.
If not so, the water in the washing machine could be drained during operation.
2. Be sure that the height of the drain hose must be less than 1.5m above the floor.
If not so, the water in the washing machine could not drain.
3. The hose guide MUST be fitted to the drain hose. The drain hose sould not extend more than 55mm
from the end of the hose guide. This is to prevent ‘SYPHONING’.
If necessary the drain hose can be trimmed to length.
1
Connect the drain hose to
the drain outlet at the back
side of the washing
machine, and fasten it
tightly with the clamp
supplied.
4
Hook the drain hose to the
edge of the tub, paying
attention that there are no
bends or constractions
along the drain hose.
2
Insert the hose fixture into
hook hole at the side of the
body, and fix the drain
hose by inserting it into the
hose fixture.
Or, connect the drain hose to a
standpipe of a diameter greater
than that of the drain hose and at a
height of min. 70cm.
3
Attach the hose guide,
included in the accwssory
kit, to guide the drain hose
over the tub or standpipe.
5
Position the washing
machine next to the wall.
Drain
hose
Drain outlet
Hook Hole
Hose Fixture
Drain Hose
Pull Hose
through
Flex Hose
Guide
apart
MUST be
ventilated
55 max.
70cm min
Hose Clamp