6
Installation place requirement
● A concrete floor is the most suitable installation surface for a
washing machine, being far less prone to vibration during the
spin cycle than wooden floorboards or a carpeted surface.
● The machine must be level and securely positioned. The
distance between the machine and wall must be more than 10
cm.
● To avoid vibrations during spinning, the machine should not be
installed on soft floor coverings.
10cm
10cm
Level adjustment
The machine must stand perfectly level on all four feet to ensure safe and proper operation. Incorrect
installation may increase electricity and water consumption and may cause the machine to move about.
To do these when the machine is not level:
● Using the spanner turn locknut in a clockwise
direction. Then turn locknuts together with adjust
feet to unscrew.
● Use a spirit level to check the machine is standing
level.
● Hold adjust feet securely with a pipe wrench. Turn
locknut again using the spanner until it sits firmly up
against the housing.
Locknuts
Adjustable feet
Loose
Locked
High
Low
NOTE :
Vibration and noise may occur if the locknuts do not sit firmly up against the houses.
Drain hose connection
1. Direct into a sink
If the outlet spigot has not been used before, remove any blanking plug that may be in place.
Push the drain hose onto the spigot and secure with a clip if required, ensure a loop is formed in the
drain hose to prevent waste from the sink entering the washing machine.
If required, the drain hose can be extended to a length of 4 m.
Loop
DWD-GM1011_영국향.indd 7
2013-09-23 오전 11:42:00
