■
Connection of Hoses
• Attach the water intake hose to the water inlet located at
the control panel. Press fit the other end of the hose to
either a hot or cold water tap as required.
• Attach the drain hose to the drain outlet at the rear of the base.
• The drain hose should be laid flat on the ground. Water flow will be restricted if any portion of the drain
hose is raised from the ground. (NON PUMP)
• Hang up the drain hose on the edge of a sink. (PUMP)
Caution:
This unit is made of poly propylene, use water
below 50
°
C
Caution:
The opening must not be obstructed by carpeting when the washing machine is installed on a
carpeted floor.
WASH TIM
ER
RO
TAT
ION LIMIT
VALVE SE
LECTOR
SPIN TIM
ER
RO
TAT
ION LIMIT
Less than 10cm
Drain Outlet
Drain hose
A
HOW TO WASH
Preparation
How to Wash
(NON PUMP)
(PUMP)
• Sort the clothes into groups-whites, colorfast, non-colorfast, delicates, lint free, lint producer, etc., and
wash according to the
LAUNDRY GUIDE.
• Clothes with worn patches or tears should first be mended. Empty out all pockets and close all side
fasteners. Treat bad stains prior to washing.
• Ensure the drain hose is in its correct position. (See
INSTALLATION
)
• Inlet power cord plug into the power point and switch on.
1
Set the wash timer knob to position “0”.
Set the Valve selector to the “WASH · RINSE” or “OFF” position. (PUMP)
Set the Valve selector to the “STRONG” or “NORMAL” position. (NON-PUMP)
2
Set the water guide knob to “WASH”.
3
Open the water faucet and feed water to the water level indicated inside wash tub.
4
Put detergent and launday into the wash tub.
5
Set wash time with the wash timer.
6
When washing is finished, set the Valve selector to the “DRAIN” position and drain the wash tub.
3
DW-6510(¿ )-Dema
01.3.26
9:21
PM
˘
`
3