Daewoo DTR-1420ME, Service Manual

Page: 6 / 58

-5-
ALIGNMENT INSTRUCTIONS
SVC KEY EXPLAIN
(S5) BCL THD : MAX BEAM CURRENT ADJUST,DIFFERENT DATA FOR INCH.
BCL GAIN : AVERAGE BEAM ADJUST.
(S6) GEOMETRY : PAL (50Hz) adjust.
AV NTSC is auto correction.
---> H-CENTER(-1),V-SIZE(0),V-600),V-LINEARITY(-6)
S-CORRECTION(0),H-PALLEL(0)
(S10) NORMAL : PICTURE NORMAL data setting.
(SLEEP) : TXT CHECK ON LINE
(SIZE) : GAME FUNCTION CHECK ON LINE
(S11) OPTION
- HOTEL VOLUME : HOTEL MODE MAX VOL DATA SETTING
- HOTEL MODE OFF : ON--> VOL MAX SET& INSTALL DONT OPERATING
* Software option for Function Change
PIP (ON)
- ON : With PIP Models (DTC-xxxxME seiese)
- OFF : Without PIP Models (DTC-xxxxMT seriese)
Digital EYE (ON)
- ON : Enable the Digital Sensor (for all Model)
- OFF : Disable the Digital Sensor
LARGE (OFF)
- ON : For 29 inch Models CM-907
- OFF : For 14~21 inch Models CM-907S
LATIN : English,French,Swedish,Czech,German,Spanish,Italian,Estonian
EAST: English,Slovakian,Hungarian,Serbian,Albanian,Polish,Turkian,Rumanian
RUSSIA : English,Russian,Bulgaian,Ukrainian,Serbian,Montenegro
TEXT sel. (OFF) PERSIAN : English,Farsi
ARAB : English,Arabic
OFF : Teletext Language depends on OSD Language selection
* Note : If OSD language & text selec. is different then Teletext depends on Text selec.
2. Heat-Run
- Press the “S1” button of Service Remote controller for ‘HEAT-RUN’
(The CRT must be heated up at least 30min. before adjusting.)
- Press the “S1” button again to release ‘HEAT-RUN’ mode.
3. Screen (G2) Alignment
3-1. Screen Alignment will be performed after sufficient Heat-Run of Set.
3-2. Please check the right EEPROM DATA
- Press S11 and ‘MENU’ button in sequence,
then the Service Main Menu will be appeared.
- Please check the right SCR BRM data in the SVC Main Menu.
All manuals and user guides at all-guides.com
all-guides.com