8
2) FOCUS ADJUSTMENT
•
Turn in a local station and adjust the Focus Control knob (located on FBT) for best picture
details at high light condition.
3) RF AGC DELAY ADJUSTMENT (S5)
•
Receive a good local channel.
•
Enter the service mode and select service adjustment S5.
•
You can see the OSD as shown in below.
•
Select RFAGCD item, press the volume up or down button until noise or beat in picture disappears.
•
Press the DISPLAY button to memorize the data.
4) GEOMETRIC ADJUSTMENTS (S6)
•
Enter the service mode and select service adjustment S7.
•
Whenever you select the “S7” using the volume up or down button, the screen is changing like this.
•
Using the volume up or down button, select internal cross pattern.
•
Select service adjustment S6
•
You can see the OSD as shown in below.
4-1. Horizontal Position Adjustment
•
Select H.PHASE item, adjust H.PHASE data value to obtain proper horizontal centering of the
internal cross pattern at the left and right of the screen.
4-2. Vertical Position Adjustment
•
Select V.POSI item, adjust V.POSI data value to center the raster properly on thescreen.
ALIGNMENT INSTRUCTIONS
IF CONTROL
AUTO RFAGC START
VIDEOL 7
RFAGCD 10
FM.LEV
20
AGC POINT 3.75
A/D VALUE : 8DH
MOVE
ADJUST RECALL : SET
GEOMETRY
H. PHASE 20
V. POSI 29
V. SIZE 70
NO SD POWER OFF YES
V SC
3
V LIN
23
MOVE
ADJUST RECALL : SET
NORMAL BLACK WHITE100 WHITE60 CROSS
Summary of Contents for DTQ-29S2FCC
Page 12: ...11 SCHEMATIC DIAGRAM CN 013 CHASSIS...
Page 13: ...12 EXPLODED VIEW 1 DTQ 29S2FCC...
Page 14: ...13 EXPLODED VIEW 1 DTQ 26S2FCC...
Page 15: ...14 PRINTED CIRCUIT BOARD...
