Daewoo DPP-42A1LCSB, Service Manual

Page: 82 / 92

- 14 -
2-8. The screen has one or several vertical
line
(1) In this case, It isn’t a problem about CTRL B/D or X B/D.
(2) It may cause followings.
- It’s out of order a panel
- Open or short of DATA TCP FPC attached panel
- It’s out of order a DATA TCP attached panel
(3) Replace Module.
[ [
Screen Display Form
2- 9. The screen has one or several
horizontal line
(1) In this case, it isn’t a problem about CTRL B/D or Y B/D.
(2) It may cause followings.
- It’s out of order a panel
- Open or short of SCAN FPC attached panel
- It’s out of order a SCAN IC attached panel
(3) Replace Y DRV B/D
[ [
Screen Display Form
2-10. The screen displays input signal
pattern but the brightness is dark
(1) In this case, Z B/D operation isn’t complete.
(2) Check the power cord of Z B/D.
(3) Check the connector of Z B/D and CTRL B/D.
(4) Replace the CTRL B/D or Z B/D.
2-11. The screen displays other color
partially on full white screen or happens
discharge partially on full black screen.
(1) Check the declination of Y B/D set up, set down wave.
(2) Measure each output wave with oscilloscope(more than
200MHz) and compare the data with below figure data.
Adjust the Y B/D Set_up(A) and Set_down(B) declination
by changing VR1 and VR2 as same writing on the
adjustment label.
- Measuring Point of Y B/D : B39
2-12. It doesn’t display a specified
brightness at specified color
(1) Check the connector of CTRL B/D input signal.
(2) Replace the CTRL B/D.
It may show several vertical
lines in a quarter or other
division part of screen
including left case.
It may show several horizontal
lines including left case.
Y Output Voltage Wave form