2
Cleaners:
The cleaners noted below are available. Never use harsh, abrasive
cleaners, heavy-duty cleaners, or solvents on any surface.
Exterior:
Wipe with damp, sudsy cloth, rinse and dry. For stubborn stains and for
periodic waxing, use silicon wax.
Evaporator:
When refrigerator needs defrosting turn thermostat dial to “OFF”. Do not
use sharp instruments.
Refrigeration Section:
Wash shelves and other removable parts in warm sudsy
water, rinse and dry. Wash interior with baking soda solution (3 table spoons to one
quart of water) or warm sudsy water, rinse and dry.
Magnetic Door Seals:
Wash with warm sudsy water.
The Finishing Touch:
Replace all parts and return thermostat dial to desired
setting.
Install refrigerator in a convenient location away from extreme heat and cold. Allow
sufficient clearance between the refrigerator and side wall so the door will open for a
fully usable interior. Refrigerator is not designed for recessed installation.
Select a place with strong level floor.
Allow 5 inches of space between the
refrigerator’s side and the wall.
If installing into a cabinet, ensure you have
good ventilation.
The electrical plug must be accessible without
moving the set.
CAUTION :
1. If the supply cord becomes damaged, it must be replaced by the manufacturer or
its service agent or a similarly qualified person in order to avoid a hazard.
2. The appliance is not intended for use by young children or infirm persons without
supervision.
3. Young children should be supervised to ensure that they do not play with the
appliance.
HOW TO CLEAN
HOW TO INSTALL
5
inches
2
HOW TO OPERATE
1. Clean the refrigerator thoroughly. Wipe the outside with a soft dry cloth, the inside
with a damp cloth.
2. Keep the door open and insert the power supply cord into the socket.
3. Turn the thermostat dial to “7”. Close the door and let the refrigerator operate for
15-20 minutes.
The freezer should then show some traces of frost.
You can control the inside temperature by
turning the thermostat dial. Higher numbers
mean greater cooling power, smaller numbers
mean less cooling power. To make ice cubes
in the freezer compartment, set the dial to “7”.
The dial does not have to be set exactly on the
numbers, but can be any place in between.
Defrost the refrigerator when the frost accumulated on the evaporator is about
5mm(1/5inch) thick.
Set the thermostat dial to “OFF”. Remove foods. Keep drip tray in place. Defrosting
usually takes a few hours. To defrost quickly remove all foods from the refrigerator and
leave door open. Never use a knife or other metal instrument to remove ice/frost from the
evaporator. After defrosting empty water from drip tray, return the thermostat dial to the
desired position to start refrigerating again.
6
7
5
4
3
2
1
OFF
CO
LD
E
R
TEMPERATURE
CONTROL
NOTE : Wait 3 to 5 minutes before restarting if you unplug the machine.
Unit may fail to operate properly if restarted too quickly.
Temperature control
Starting your new Refrigerator
How to defrost
