ENG
Front view
Back view
RCC Mode start
RCC Received
11
WIRELESS REMOTE SENSOR REGISTRATION PROCEDURE
1. Insert 3 pieces of AA batteries fi rst to the main unit. The temperature display shows - - . – while
the wave icon will keep blinking for 2 minutes indicate the main unit is in sensor searching mode.
2. In a second step, insert the 2 pieces of AA batteries into the sensor unit. The LED on the front
panel will start fl ashing at a rate of one time per around 2 seconds indicates channel-1 is in use.
3. While the LED is fl ashing, press once the
[CH]
key will change the sensor channel setting to 2.
Keep toggle on
[CH]
key can change channel setting up to 3. The LED is blinking at a frequency to
indicate the channel setting. i.e. continuous blinks 2 times indicate channel-2 is selected.
Note: If user does not press any key for 10 seconds, it will exit the channel setting mode and
transmit the RF signal. The main unit will register the temperature reading.
REMOTE CHANNEL AUTO-SCROLLING
This device is equipped with an auto-scroll function. While the auto-scroll function is set, the
unit will automatically cycle to display the temperature and humidity of each remote sensor for
6 seconds.
1. To retrieve manually the specifi c sensor temperature and humidity reading, press CHANNEL key
until desired channel number is displayed.
2. To enable auto-scroll function, use CHANNEL button to toggle channel 1, 2 or 3 until auto scroll
icon appears on the left hand side of the second line display.
DCF 77 RADIO CONTROLLED CLOCK
The radio-controlled time is calculated by the Cesium Atomic clock of Braunschweig (offi
cial clock
of Germany).
Then the time is coded and transmitted from Mainfl ingen - near Frankfurt - via a signal on DCF-77
(77.5 kHz). The transmitting range of the signal is 500 km, which means that most of Western and
Central Europe is covered by this signal. Within this range the received time is completely accurate.
Once sensor signal(s) are received, the wave icon will fl ash to indicate that the receiving unit starts
to receive the DCF radio controlled time signal.
Once the time signal is received, the wave icon will stay on the LCD, and time and calendar will
automatically be updated.
Note: During the 10-minute time signal reception, all manual settings will be suspended. If
setting is desired, press once [ ] key to deactivate the reception. You can also press and
hold the same key for 3 seconds to manually activate the reception in normal mode.
