5
Verifying the Package Contents
If any item is missing or damaged, please
contact your dealer immediately. Do not
install a damaged or incomplete appliance.
• Use and care manual
• Anti-tip bracket
• Broiler grill and pan
• Oven racks
• Razor blade scraper
• Dacor Cooktop Cleaning Cream
Installing the Anti-Tip Bracket
WARNING:
This appliance requires an anti-
tip device. Before installing
the range, you must locate and
secure the anti-tip bracket to the
floor.
When the range is slid into position in the
cutout, the left rear leveling leg slides into
this bracket to prevent the unit from tipping
forward. The bracket location shown here
will position the rear edge of the range
top frame flush to the rear wall. From this
position, the bracket allows for up to 5/8”
(16mm) of forward movement of the range.
1 1/2” (38mm)
11 3/8”
(289mm)
2 3/16”
(56mm)
Front face
of cabinet
19 7/16”
(494mm)
CL
Top View - Location of Anti-Tip Bracket
Based on 24” Cabinet Depth
Removing the Oven Door
WARNINGS:
1. Do not attempt to disengage
the hinge catches with the
door removed from the oven.
The hinge springs could
release causing personal
injury.
2. Do not lift or carry the oven
door by the door handle.
Open the door to its fully opened position.
Rotate the catch over the retaining arm
on each hinge. Lift the oven door to about
a 30 degree angle from the horizontal
position. Pull the door away from the oven
while continuing to lift.
30º
2) Lift door up to 30º angle, then
pull door away from the oven
1) To remove door, rotate catch up
Removing the Oven Door
Remove the Kick Panel
Remove the screw at each top corner of
the kick panel. Lift up slightly on the panel
and pull forward to remove.
Electrical Connection
NOTE:
See the range data plate for
electrical specifications. See
page 1 for location.
WARNINGS:
1. All of these range models
must be connected to a
grounded, metallic, permanent
wiring system. Alternatively, a
grounding conductor should
be connected to the grounding
terminal or lead on the
appliance.
2. Do not use an extension cord
with this appliance. Such use
may result in fire, electrical
shock, or other personal
injury.
3. Do not install a fuse in the
neutral or ground circuit. A
fuse in the neutral or ground
circuit may result in an
electrical shock hazard.
4. Do not ground the appliance
to a gas supply pipe or hot
water pipe.
5. A grounded cold water pipe
must have metal continuity to
electrical ground and must not
be interrupted by insulating
materials. Any insulating
materials must be jumped
with a length of No. 4 copper
wire securely clamped to bare
metal at both ends.
Connection Instructions: This appliance
must be electrically grounded.
With the range positioned directly in front
of the cabinet cutout, feed the appliance
conduit into the electrical junction box.
Then, depending upon local codes, utilize
one of the techniques on the facing page
to connect the appliance to the electrical
power supply.
WARNING:
This appliance must be installed
by a licensed plumber or gas
fitter when installed within the
Commonwealth of Massachusetts.
