Dacor Epicure ERD30, Use And Care Manual

Page: 15 / 20

13 13
Oven will not work.
Door will not open.
Oven will not heat after Self-Clean.
Ignitors do not spark.
Sparking but no flame ignition.
Burners ignite but flame is extremely large,
distorted or yellow.
Burner flame goes out at low setting.
Ignitors spark continuously after flame ignition.
Oven is set for Delay Timed Cleaning
Light bulb is burned out.
Oven is in Self-Clean mode.
Time of day is not set dure to power failure.
Oven settings are not correct.
Oven is set for Delayed Time mode.
Circuit breaker is tripped.
House fuse is blown.
Power outage in local area.
Gas shut-off valve is in “off” position.
Gas supply is interrupted.
Burner ring ports are clogged.
Burner ports or burner caps are not positioned
properly.
Cooktop is being operated on the wrong type
of gas.
Regulator is not installed, is faulty or is set for
the wrong type of gas.
Low gas supply pressure.
Air intake holes around knobs are obstructed.
Power supply is not grounded.
Power supply polarity is reversed.
Ignitors are wet or dirty.
Oven will turn on automatically at preset time. If
desired, press “CANCEL•SECURE” touch pad
to cancel out of Delay Timed Cleaning
Follow REPLACING THE OVEN LIGHT.
If oven is hot, door latch will release
automatically when oven temperature falls below
390˚F at end of cycle.
If Self-Clean was just selected and the oven
is still cool, press “CANCEL•SECURE” to turn
off Self-Clean. The door will open in about 30
seconds.
Press “CLOCK” touch pad, then press
“TIME•TEMP” pad to set correct time of day.
Follow mode selection and clock settings as
specified in OVEN OPERATION.
Oven will turn on automatically at present time.
If desired, press “CANCEL•SECURE” button to
cancel out of Delay Timed mode.
Reset circuit breaker.
Replace house fuse.
Contact power company.
Turn shut-off valve to “on” position.
Contact gas company.
Clean burner ring ports with straightened paper
clip, needle or wire.
Remove and carefully re-install burner rings and
caps.
Ensure that the type of cooktop matches the gas
supply (natural gas or L.P. gas).
Check installation, replace regulator, or set
regulator for proper gas.
Contact gas company.
Remove obstruction.
Have power supply properly grounded.
Have polarity corrected.
Dry or clean ignitors.
Troubleshooting Guide (Continued)
Clock Display Cause
F0 Touch pad is stuck in a depressed position.
F1 Relay circuit failure.
F2 Oven temperature exceeded the clean runaway temperature (Self-Clean mode only) or the cooking runaway temperature (cooking
modes only).
F3 Short circuit in the oven temperature sensor.
F4 Open circuit in the oven temperature sensor.
F6 Failure in the EEPROM check comparison. (Only time of day and timer will operate.)
F7 Failure of the Self-Clean automatic door latch circuit.
F8 Failure of the door latch motor.
Oven Failure Codes