Dacor EF24LBCSS, Use & Care Manual

Page: 7 / 16

4 5
o
perating
y
oUr
a
pplianCe
Turning on the Fan
When storing wine for long periods of time, turn on the fan. The
fan will increase the humidity level, which prevents bottle corks
from drying out. The fan will run continuously until turned off.
To turn on the fan, push the
LIGhT
and
ALARM
buttons at the
same time.
When the fan is on, pushing the
LIGhT
and
ALARM
buttons at
the same time turns it off.
Alarm
The alarm helps to protect your wines against
excessive temperature fluctuations. The alarm
sounds when the door is open for longer than
about 60 seconds. It also sounds when the interior
gets too warm or too cold. The temperature
display will also flash. It will continue to flash until
the temperature problem has been fixed, even if
the alarm has been muted.
To mute the alarm, push the
ALARM
button.
Interior Lighting
You can set the interior lighting so that it is on all
the time, or so that it comes on only when the
door is open.
To make the light stay on (or turn off)
when the door is closed:
Push the light button.
•
•
•
•
Setting Up the Display (Set-up Mode)
In set-up mode you can turn the child-resistant lock on and off
(see page 6 for details), set the temperature scale to Fahrenheit
or Celsius, and adjust the brightness of the display.
Changing the temperature scale (ºF or ºC)
You can select the temperature scale that the unit uses to display
the temperature settings:
Push and hold the
LIGhT
button for about five seconds to enter
set-up mode. The display will begin to flash.
Push the
UP
button until the degree symbol “
º
“ flashes on the
display.
Push the
LIGhT
button.
ºF
or
ºC
will flash on the display.
Push the
UP
or
DOWN
button until the desired temperature
scale flashes on the display. Push the
LIGhT
button to select
the desired temperature scale.
Push the
ON/OFF
button to exit set-up mode.
Within about two minutes, the appliance will change the
temperature scale on the display.
To change the display brightness
Push and hold the
LIGhT
button for about five seconds to enter
set-up mode. The display will begin to flash.
Push the
UP
button until an “
h
“ flashes on the display. Push the
LIGhT
button. The current display brightness level, from 1 to 5
will flash on the display.
h1
is the lowest level.
h5
is the highest
level.
Push the
UP
or
DOWN
button until the desired brightness level
flashes on the display. Push the
LIGhT
button to select the
desired brightness level.
Push the
ON/OFF
button to exit set-up mode.
•
•
•
•
•
•
•
•
•