Dacor ● 600 Anton Blvd. Suite 1000 Costa Mesa, CA 92626 ● Phone: (800) 793-0093 ● Fax: (626) 403-3130 ● www.dacor.com
Millennia Style Handle Installation
(ADWM24H/ ARDWM24H)
Epicure Style Handle Installation
(ADWE24HCH/ADWE24HB)
Handle mounting
studs
Handle mounting
studs
Set screw
holes
Set screw
holes
STEP 1
Place the handle on the front of the dishwasher. Slide
the holes on the back over the handle mounting studs.
Make sure the set screw holes on the handle are fac-
ing toward the bottom. You may need to loosen the set
screws using a 3/32” Allen wrench to allow the handle
to slide into place.
STEP 2
Carefully tighten the set screws into place using the
3/32” Allen wrench. Be careful not to scratch the finish.
STEP 3
Check to make sure the handle is firmly attached.
STEP 4
Open the door to make sure it stays open at any angle.
If it tends to fall open or pull shut on its own, adjust the
springs according to the dishwasher installation instruc-
tions.
IMPORTANT:
For dishwasher models IDWH24 and RDW24I with glass panel kit: Install this
handle kit according to the instructions provided with the glass panel kit. For
dishwasher models EDWH24S and RDW24S, see the instructions below.
Instructions
