Dacor EDWH24S, Installation Instructions Manual, Page: 14 / 20

12
4. If a nonmetallic cable is being used, install a
UL-listed strain relief bushing on the back of the
dishwasher.
5. Connect the white wire on the cable to the “N”
terminal on the dishwasher terminal block as
shown below.
6. Connect the black wire on the cable to the “L”
terminal on the terminal block.
7. Connect the ground (green) wire on the cable
using a loop or spade terminal to the ground
connection screw located on the dishwasher
chassis.
8. Re-install the electrical access panel and the toe
kick brackets.
Installing the Unit in the Cabinet
1. Position the dishwasher in front of the cabinet
opening.
2. Before sliding the unit into the cutout, make sure
the drain hose, water supply line and power cable
are positioned in the utility cutouts as shown
below. Make sure each is routed to the side it will
be connected.
Installation Instructions
3. Slowly and gently slide the unit into the
dishwasher opening. As you do this, have
someone gently pull the drain hose, water supply
line and power cable through the access hole(s)
into the adjacent cabinets. Exercise care to make
sure that the wiring and plumbing lines do not
become damaged.
4. Once the dishwasher is in place check to make
sure all slack is pulled out of the power cable,
water supply line and drain hose. Check to make
sure none of them are pinched or kinked.
NOtE: Do not attach the mounting screws until after
Verifying Operation .
Water Line Connection
CAUtION
The unit has a float switch in the base pan to
protect against flooding. If the inlet valve connection
is not seated properly, water may leak into the base
pan and activate the float switch.
1. Before connecting the water supply, line make
sure the water pressure and flow rate meet the
specification on page 4.
2. Flush the water supply line prior to connecting it
to the dishwasher’s water supply line.
3. Insert the provided
“O” ring in the end
of the water supply
line. Make sure it
is evenly seated on
the end of the tubing.
4. Connect the end of the water supply line to the
water line. Tighten the connection by hand plus a
quarter turn with a crescent wrench.
continued...
Power cable and
water supply line
Drain hose
Drain house
Water supply
line
Power
cable
Neutral (N)
terminal
Junction
box
To house power supply
Terminal
block
White to
white
(neutral)
Black to
black (line)
Green to
green
(ground)
Line (L)
terminal
Ground
connection
screw (chassis)
Permanent Wiring Connection