PLANNING
GUIDE
www.Dacor.com Phone: (800) 793-0093
Specifications subject to change without notice.
Install all appliances according to accompanying installation instructions.
10.5
EDWH24S, IDWH24
24” Wide Built-In Dishwasher
Document # PG10-005
Revised 07/16/10 Page 3/3
ExAmPLE oF DrAIN CoNNECtIoN WItHoUt AIr GAP
ExAmPLE oF DrAIN CoNNECtIoN WItH AIr GAP
Drain Specifications
The drain connection must be a minimum of 20 inches (50.8 cm)
■
above the floor. No part of the drain hose can be higher than 37 1/2”
(95.0 cm) from the bottom of the dishwasher.
Should a drain hose longer than the one provided be required, use a
■
hose extension approved for detergents and high temperature water.
Total drain hose length (including any extensions) must not exceed
■
14 ft. 9 in. (450 cm) in length from the top of the drain loop on the
back of the unit. Joints and joint tubes must have a minimum inside
diameter of 5/8” (1.6 cm).
The drain hose supplied with the dishwasher must be connected
■
to a minimum 1/2" inside diameter drain connection. A clamp is not
supplied. The drain hose is equipped with a connector that fits drain
connections with an internal diameter of 1/2 to 7/8 inches (1.3 to
2.2 cm).
Install an air gap in the drain system if required by local codes.
■
Plan the air gap location on the countertop area adjacent to the
dishwasher. A section of drain hose (not provided) needs to be
installed from the air gap to the drain connection.
If an air gap is not required, the drain hose must be installed to a
■
disposer inlet or waste tee above the drain trap in the household
plumbing.
20"
Min.
20"
Min.
