Dacor ED 24, Installation Manual, Page: 35 / 42

Intro
Diagnostic Test
Components ON
Duration (sec) Comments
Drain Pump 30 Control Board version displayed; Full drain see
drain logic
Inlet Valve 60 Most significant Failure code; Full fill see Fill logic
Pause 20
Circ Pump & Heater 300 Temperature is read once every minute
Dispenser 5
Drain Pump 30
•
All LEDs on the dishwasher will turn ON for about 15 seconds then turn OFF.
• Temperature measurement is taken one (1) minute after the circulation Pump is ON and
immediately after the Heater turns OFF.
• At the end of the test the In Process LED will be ON indicating that the Diagnostic test passed.
• Any fault code that is detected will be displayed. The fault code displayed will be displayed until
the CANCEL key is pressed.
• If more than one fault is detected during the Diagnostic test, only the first detected fault code will be
displayed until it is corrected.