Dacor DOB30M977 Series, Installation Instructions Manual

Page: 10 / 108

English 10
Installation requirements
Installation requirements
Location requirements
IMPORTANT : Observe all governing codes and ordinances.
• Cabinet opening dimensions that are shown must be used.
Given dimensions provide minimum clearance with oven.
• Recessed installation area must provide complete enclosure around the recessed
portion of the oven.
• Grounded electrical supply is required. See “Electrical Requirements” section.
• Electrical supply junction box should be located 3” (7.6 cm) maximum below the
support surface when the oven is installed in a wall cabinet. A 1” (2.5 cm) minimum
diameter hole should have been drilled in the right rear or left rear corner of the
support surface to pass the appliance cable through to the junction box.
NOTE
For under counter installation, it is recommended that the junction box be located in the
adjacent right or left cabinet. If you are installing the junction box on rear wall behind
oven, it is recommended that the junction box be recessed and located in the upper Right
of the cabinet.
• Oven support surface must be solid, level and flush with bottom of cabinet cutout.
• Floor must be able to support a single oven weight of 221 lb (100 Kg).
• Floor must be able to support a double oven weight of 375 lb (170 Kg).
• Install Oven at least 12” (30 cm) away from other appliances.
IMPORTANT : To avoid damage to your cabinets, check with your builder or cabinet
supplier to make sure that the materials used will not discolor, delaminate or sustain other
damage. This oven has been designed in accordance with the requirements of UL and CSA
International and complies with the maximum allowable wood cabinet temperatures of
194 °F (90 °C).
NW9000K_MOD_DOB30M977DS_DG68-00923A-01_EN+MES+CFR.indb 10 10/16/2019 12:50:49 PM