32
pull the light bulb straight out of the light socket (do
•
not turn).
using a glove, insert the new bulb into the socket.
•
replace the bulb only with Dacor part No. 92317,
available from any authorized Dacor parts dealer.
reinstall the lens cover by aligning the cover over the
•
opening and gently pressing it into its original posi-
tion. Be sure that the side of the lens cover with the
cutaway is in the front, by the socket.
Turn the power to the oven back on at the main power
•
supply.
Optional Baking Stone
Wash the optional baking stone with hot water and
•
scrub it clean before you use it for the first time. Do
not use any soap or detergents to wash the stone.
The stone is porous and soap will get trapped inside.
The trapped soap will affect the flavor of the food
cooked on it. Don’t be alarmed if the stone gets stains
on it after it is used for a while. Stains do not affect
the stone’s ability to bake properly.
When you need to remove large food particles from
•
the baking stone, use warm water and a scrub brush.
If there is a lot of oil build-up, it may smoke and
create odors. If you need to remove the oily build up,
use a scouring pad or brush to remove it. You may
also use a paste of baking soda and water to scrub
small stained spots off.
Optional Cookie Sheets
Clean aluminum cookie sheets with a solution of
•
detergent and warm water. Since aluminum can
scratch, you need to use the soft side of a sponge. A
way for you to keep cookie sheets cleaner is to use
parchment paper over the cooking surface during
baking. The parchment paper will also prevent food
from sticking.
Light bulb replacement is considered to be a homeowner
maintenance operation.
warning
To prevent electrical shock and/or personal injury,
•
make certain that the oven and light bulb(s) are
cool and that power to the oven has been turned off
at the main power supply before replacing the light
bulb(s).
Always ensure that the lens cover is in place
•
when using the oven. The lens cover protects the
bulbs from breakage that can be caused by high
temperatures or being bumped.
ImPortant:
Do not touch the halogen light bulbs with
your fingers. Halogen light bulbs are sensitive to the oils
from your hand. The oils from your hand will stick to the
bulb and cause it to burn out faster than normal. use a
glove when handling them.
ImPortant:
use the pry stick with caution. Do not
cause uneven stress on the lens cover.
note:
If the lights do not work, before replacing them,
please consult the Before You Call for Service Guide on
page 33.
To Replace the Light Bulb(s):
Turn off power to the oven at the main power supply.
•
Each light assembly consists of a light fixture housing,
•
a removable lens cover, and a 12 volt halogen light
bulb. See page 5 for the location of the light fixtures.
Gently insert the pointed end of the supplied pry stick
•
under the center edge of the lens on the side facing
the oven door and pry it loose. Support the bottom of
the lens with your hand as you pull it straight out.
Care and Cleaning
Replacing the Light Bulbs
Lens pry
stick
light Bulb replacement
Light bulb
Cutaway: line up with
light socket
Light socket
Lens
Summary of Contents for Discovery EO127
Page 2: ...Copyright 2007 by Dacor All rights reserved...
Page 37: ...35 Notes...
Page 38: ...36 Notes...
