Dacor DHW301, Installation Instructions Manual

Page: 8 / 16

6
Installing the Mounting Bracket
(Continued)
Locate the verti- 3.
cal center line for
the hood mount-
ing location on
the wall. Mark the
center line with a
six inch vertical
line that intersects
the line drawn in
step 2.
Make sure the
4.
mounting location
is properly rein-
forced so that it
will hold the weight
of the hood.
Find the mounting bracket in the shipping box. Place
5.
it against the wall where the two lines cross. Center
it vertically and line the top of the bracket up with the
horizontal line as shown.
Making sure the bracket is level, use a pencil to 6.
mark the mounting hole locations through the bracket
holes.
Drill the mounting holes. The method for drilling the
7.
holes depends on the type of mounting surface...
if mounting the hood to brick or masonry:
Drill three 5/16” x 1 1/2” holes in the locations ■
marked.
Insert three of the provided wall anchors into the ■
holes. The anchors provided are for attaching the
hood to masonry or brick only.
if mounting the hood to drywall:
Drill three appropriate sized pilot holes for the ■
mounting hardware being used. The drywall
mounting hardware must be purchased sepa-
rately.
Attach the mounting bracket securely to the wall. 8.
Installing Chimney Mounting
Bracket
Locate the chimney mounting bracket and position it 1.
against the ceiling as shown. Center it on the hood
center line.
Mark the ceiling and the wall in two places each,
2.
through the holes in the bracket.
Drill four 5/16” holes through the four spots marked
3.
on the ceiling and wall.
Insert the four of the provided wall anchors into the
4.
four holes on the ceiling and wall.
Attach the chimney mounting bracket using four
5.
included 1 1/2” screws.
Installation Instructions
Mounting
bracket
Anchors
Chimney
mounting bracket
CL
CL
Hood center
line
Height of
mounting
bracket
(step 2)
CL
CL
Line up
center hole with
center line
Line horizontal
line up with this
edge
Mounting
bracket
Anchor