Dace Technologies MEGA-T300b, Instruction Manual, Page: 16 / 52

- - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - ▲
I
NSTRUCTION
M
ANUAL
MEGA-T300b
Abrasive Cutter
3601 E. 34th St. Tucson, AZ 85713 USA Tel. +1 520-882-6598 Fax +1 520-882-6599 email: pace@metallographic.com Web: http://www.metallographic.com
Please read this instruction manual carefully and follow all installation, operating and safety guidelines.
4.0 Start - up and Operation
4.1 General
The MEGA-T300 is a manual wheel and manual table feed cutter .
12
4.2 Control Panel
Coolant
ON/OFF
Cutting wheel ON/: Starts the cutting wheel.
Cutting wheel OFF/: Stops the cutting wheel (inductive brake engages to slow
wheel). Hood cannot be opened until safety lock releases in
approximately 5 seconds after pressing the stop button.
Coolant ON/OFF: Operates the coolant pump in Auto or Manual mode.
Light ON/OFF: Turns inside chamber light On or Off.
Ammeter: Number of amps being pulled by the motor.
Amp overload signal
light: Red light turns on if too many amps are being pulled by the
motor. This is a warning light to indicate that the cutting
force needs to be reduced.
Cutting
wheel (ON)
Light
ON/OFF
Cutting
wheel (OFF)
Power
Light
Amp overload
signal light
Ammeter