Setup
1.
Using the telephone line cord supplied, plug one end into the unit’s
Data
jack (located on the back), and the other end into the system or
phone jack.
2.
Connect the power adapter to the A/C jack on the unit’s left side.
3.
Lift the dialer directory card and plastic off the top. Remove the
plastic tab from underneath. This activates the internal battery for dialer
memory.
4.
Plug the handset cable into the unit’s left side.
Auto-Log
One-touch dialer #10 (bottom right) is used for the Auto-Log feature. If
DIP switch 1 is on, whatever is programmed to this dialer will
automatically be dialed. This could be a phone number or perhaps user
ID.
DIP Switches
On the bottom of the unit, there are two DIP switches. To access them,
you must slide the plastic cover down. There are four additional DIP
switches located underneath the dialer directory card on the top of the
unit; these are not used. The functions for the bottom two are listed
below.
DIP Switch 1:
On=Enables Auto-Log for dialer #10.
DIP Switch 2:
On=Enables
Record Latch
(REC button toggles).
Flash
On the back of the unit is a switch labeled
FLASH
. There are three
options:
600
,
300
, or
100
. Always leave it to
600
or you may have
issues with the
DISCONNECT
function.
Programming Dialers
Before proceeding, verify that you have followed
Setup steps 1-3
and
that
DIP swith 1 is off
.
1.
Pick up the handset and then connect to your system (this may
require entering a user ID and even dialing a telephone number).
2.
Press
Store
.
3.
Dial the number(s) you wish to have stored.
4.
Press the one-touch dialer you desire to program.
Repeat steps 2-4 for additional dialers.
Emulation
There are 5 different emulations for this model. The emulation
determines what processor your unit has and thereby what digits are
sent with certain functions.
C-Phone
will have
-C
at the end of the model (DA-110P-C).
DVI
will have
-D
at the end of the model (DA-110P-D).
Lanier
will have
-L
at the end of the model (DA-110P-L).
Winscribe
will have
-W
at the end of the model (DA-110P-W).
Voice Solutions
will have
-S
at the end of the model (DA-110P-S).
Name
Processor Record Rewind Play
Stop
New
Job
C-Phone
M123D
D
7
B
B
8
DVI
M123B
D
B
3
A
*9
Lanier
M124M
2
3
1
4
5
Winscribe
M124W
1
7
2
8
5
Voice Solutions M124B
D
B
C
A
* *
NOTE:
You can see the processor version on a sticker located beneath
the DIP switches, on the bottom of the unit. To see it, you will have to
slide the plastic cover down.