ENGLISH
49
8.3.3
Level probes
Indicate the level probe as the type of control.
Once the control type has been configured, see section 8.3.4 Concluding configuration.
8.3.4
Concluding configuration
Pump exchange mode
One of the following intervals can be set:
-
At restart
-
Every 2 hours
-
Every 4 hours
-
Every 8 hours
-
Every 12 hours
-
Every 16 hours
-
Every 20 hours
-
Every 24 hours
-
Never
The choice of exchange mode is necessary to prevent wear of
a single pump.
Enable water flow rate estimation function
To enable this function, refer to the chapter 8.3.5 Enabling water flow rate
This option, which is only available when using the depth sensor, allows
you to monitor the amount of liquid in the tank.
If this function is not enabled during the Filling or
Draining Configuration, it can no longer be activated.
This will only be possible by resetting to the factory data.
The system is ready
All the parameters have been set, the system is now in standby.
From here you can choose whether to access the "Main
Menu" or set the "Optional Configurations".
Refer to the respective chapters 8.5 Main menu and 8.4
8.3.5
Enabling water flow rate estimation
Tank shape
You can set the shape of the tank from those listed:
-
Parallelepiped
-
Cylinder
Once the shape has been chosen, indicate the volume by setting the
largest side/diameter and the smallest side of the section.
Once configuration is complete, the system will be ready but in standby.
You can choose whether to access the "Main Menu" or set the "Optional Configurations".
Refer to the respective chapters 8.5 Main menu and 8.4 Optional configurations.
