Commissioning
Transmitters need to be ‘introduced’ to the receiver. Each transmitter has a unique code, this can’t be
changed. The receiver ‘learns’ the transmitter code by pressing the self-teach button (SW1) on the
receiver. Each setting is confirmed with the LED’s on the receiver. Each receiver will accept up to 85
transmitters.
•
1 channel receiver
Introducing a transmitter to the receiver
1. Press the ‘self-teach’ button (SW1) on the receiver, LED (D1) will light.
2. Press the transmit button on the transmitter, it is possible to program more transmitters as long as
the LED is lit.
- The receiver has now registered the transmitter’s code and the LED on the receiver flashes.
When the LED has gone out, repeat the above if more transmitters are to be introduced.
Check that the receiver output becomes active when the transmitter button is pressed.
Removing one transmitter button from the system
1. Press the self-teach button on the receiver.
2. Transmit a signal with that specific transmitter button that is being removed.
3. That transmitter button is now removed from the system. Be aware of that if more than one
transmitter button has been ‘introduced’ to the receiver will these work anyway.
4. Repeat for any other transmitters that are being removed.
•
4 channel receiver
Introducing a transmitter to the receiver
1. Press the ‘self-teach’ button (SW1) on the receiver, LED (D1) will light.
2. Press the button again to select the output that is being programmed (the appropriate LED is lit
above the selected output).
3. Transmit a signal from the transmitter whilst the LED is lit. It is possible to program more
transmitters as long as the LED remains lit.
-
The receiver has now registered the transmitter’s code and the LED on the receiver flashes.
Repeat the above if more transmitters are to be added.
-
Check that the output actives on a signal; the LED illuminates when the transmitter button is
pressed.
Disabling a channel from a transmitter
1. Press the ‘self-teach’ button until the LED is lit.
2. Press the button again to select which channel is to disabled (LED is lit above the chosen output).
3. Transmit a signal with the channel to be disabled. Repeat for any other channel to be disabled.
- The receiver confirms reception by the two LED’s D3 and D4 flashing twice.
User manual
DB317 and DBR1-M4
edition 5
6
