2
tools required for Installation
1. Hang case and attach to support structure with bolts.
see suggested Methods of Installation.
2. tighten bolts until trim flange is flush with ceiling.
NOTE:
for proper operation, screen assembly must be level
after installation.
3. remove 2 screws to open junction box. Install electrical
connections that apply to your unit. Make sure to review the
wiring diagram for proper hook up. replace junction box cover
and secure with 2 screws.
NOTE:
Must be installed in accordance with the requirements of
the Local Building codes, the canadian Electrical code (cEc),
cAn/csA c22.1 and the national Electric code (nEc), nfPA 70.
If your case was ordered in advance of the screen and roller
assembly, your installation is now complete. continue to
step 4 if your tensioned Advantage Electrol was ordered as a
complete unit.
4. use supplied 1/8" hex key to remove silver shipping brackets
attached to slat and screen case.
5. test installation by running screen up and down a few times.
Be prepared to stop screen should any objects obstruct the
movement of the screen. to prevent damage to the motor, the
standard duty cycle is 1 minute on and 3 minutes off.
case Installation
Important safety Instructions
When using your video equipment, basic safety precautions
should always be followed, including the following:
1. read and understand all instructions before using.
2. Position the cord so that it will not be tripped over, pulled, or
contact hot surfaces.
3. If an extension cord is necessary, a cord with a current rating at
least equal to that of the appliance should be used. cords rated
for less amperage than the appliance may overheat.
4. to reduce the risk of electric shock, do not disassemble this
appliance. contact an authorized service dealer when repair
work is required. Incorrect reassembly can cause electric shock
when the appliance is used subsequently.
5. the use of an accessory attachment not recommended by the
manufacturer may cause a risk of fire, electric shock, or injury to
persons.
Pre-Installation
1. carefully unpack case from shipping carton.
2. set aside the Installation kit. Items inside will be used during
installation.
3. Make sure to recheck measurement of case for proper
installation clearance.
4. remove any protective foam covering the outside of
the case.
5. for shipping purposes, foam is also inserted between the roller
brackets and endcaps (figure 1). remove these foam blocks from
the ends.
6. remove the hanger brackets from the top of the case using a 1/2”
wrench. Do not discard the hardware; it will be used during case
installation to re-attach the hanger brackets for mounting.
1/2“ open Wrench
or socket Driver
1/8” Hex key
(included)
