PRE-INSTALLATION
1
1. Carefully unpack screen and remove outer wrapping from case.
2. Make sure to recheck measurements of screen location before installation.
DRYWALL
SCREW
ACCESS PANEL
MACHINE SCREW
PICTURE SURFACE
SCREEN
MOTOR #1
SLATS
MASK
MOTOR #2
JUNCTION BOX
BUS INTERFACE UNIT
CONTROL
WIRES
HEX HEAD SCREW
SHIPPING BRACKET
MASK
SURFACE
TRANSFORMER
JUNCTION
BOX
ELECTRICAL OUTLET
ON THIS END OF CASE
FIGURE 1
FIGURE 2
IMPORTANT SAFETY INSTRUCTIONS
When using your video equipment, basic safety precautions should always be followed,
including the following:
1. Read and understand all instructions before using.
2. Position the cord so that it will not be tripped over, pulled, or contact hot surfaces.
3. If an extension cord is necessary, a cord with a current rating at least equal to that of the
appliance should be used. Cords rated for less amperage than the appliance may
overheat.
4. To reduce the risk of electric shock, do not disassemble this appliance. Contact an
authorized service dealer when repair work is required. Incorrect reassembly can cause
electric shock when the appliance is used subsequently.
5. The use of an accessory attachment not recommended by the manufacturer may cause a
risk of fire, electric shock, or injury to persons.
SAVE THESE INSTRUCTIONS
