3
MORE SCREEN DROP
1. Place operating switch in
“down”
position.
2. When the screen stops, turn the white
“down”
limit knob (Fig. 2) one-quarter turn counterclockwise. Test by raising
picture surface approximately two feet, then lower again. Repeat until desired picture surface position is attained.
CAUTION: Do not adjust for more drop than what was ordered. At least 1-1/2 wraps of fabric must remain on the roller. This
screen comes standard with 12" black at the top.
LESS SCREEN DROP
1. Raise picture surface approximately two feet above desired level.
2. Place operating switch in
“off”
position.
3. Turn the white
“down”
limit switch (Fig. 2) one-quarter turn clockwise. Test by raising picture surface
approximately two feet, then lower again. Repeat until desired picture surface position is attained.
TENSIONED ADVANTAGE
®
DELUXE ELECTROL
®
INSTRUCTIONS
220 / 240V WIRING DIAGRAM
WITH ONBOARD LVC
120V WIRING DIAGRAM
WITH ONBOARD LVC
BLACK
WHITE
WHITE
RED (UP)
GRAY
BLACK (DOWN)
GREEN
DOOR SWITCH
SCREEN MOTOR
BLACK
WHITE
BLACK AND YELLOW
LOW-VOLTAGE
WALL SWITCH
BLACK
WHITE
RED
OPTIONAL RF OR IR
REMOTE CONNECTOR
LVC BOARD
WHITE (COMMON)
BLACK (DOWN)
RED (UP)
INPUT
GROUND
BLACK (HOT)
WHITE (COMMON)
120VAC 60HZ
INPUT
DOOR MOTOR
BLACK (CLOSE)
WHITE
RED (OPEN)
GREEN
DOWN
STOP
UP
BROWN
BLACK
BLUE
BLUE
BLACK (UP)
GRAY
BROWN (DOWN)
GREEN
DOOR SWITCH
SCREEN MOTOR
BROWN
BROWN AND
YELLOW
LOW-VOLTAGE
WALL SWITCH
AUX EYE
LVC BOARD
INPUT
GROUND
BLACK
BROWN (HOT)
BLUE
BLACK
BROWN (DOWN)
BLACK (UP)
220/240VAC 50/60HZ
INPUT
DOOR MOTOR
BROWN (CLOSE)
BLUE
BLACK(OPEN)
GREEN
DOWN
STOP
UP
RED
NOTE: Electrical connections on left end of
case.
NOTE: Electrical connections on left end of
case.
BLACK
WHITE
RED
EYE AUX
OPTIONAL RF OR IR
REMOTE CONNECTOR
▲
!
