3
1.
To install the Pro Imager over a Da-Lite Perm-Wall screen you will need to place the supplied wooden spacers
between the screen and the wall.
Da-Snap and Imager screens do not require any spacers.
2.
Refer to figure 3 for hanger bracket location. Dimension A will vary depending on the type of screen you have.
Dimension A is measured from the top of the screen frame to the top of the hanger bracket.
Screen type
Dimension A
Perm-Wall
3-7/8"
Imager
3-7/8"
Da-Snap
4-3/8"
Securely fasten the hanger bracket to the wall. It is recommended that you
use #10 x 1-3/4" wood screws (not supplied) and fasten into the wall stud.
Use a level to make sure the bracket is level.
To provide easy access to the limit control switches (see adjustment proce-
dures) you will need at least 7" clearance above the top of the Pro Imager.
3.
Hang the frame assembly on the hanger bracket as shown in figure 3.
4.
Fasten the bottom bracket to the wall with the appropriate type fastener for
your wall.
INSTALLATION (Continued)
HANGER
BRACKET
A
SPACER
BLOCK
FIG. 3
S
C
R
E
E
N
