2
Setting Up Your Screen
Important Parts Of Your Da-Lite Screen
Using Screen In Lowest Position
1. Hold screen vertically with tripod just above floor.
With toe, press straight down on toe release plate.
Tripod legs will glide open.
2. Pull out Black Locking Knob at top of bottom tube.
3. Raise extension tube to first position, and then swing
case to horizontal position.
4. Raise screen surface and pull bail over hanger.
If Keystone Eliminator is to be used, (1) simply grasp the
knurled tip which protrudes slightly above the hanger; (2) pull
straight up; (3) then lay in a horizontal position over the
hanger, and place the pull bail on it.
5. Release Black Locking Knob and fabric tension lock
lever on handle.
6. Holding extension tube with one hand and releasing
Black Locking Knob with other, raise extension tube to
desired position.
7. The case position may be changed by pulling out the
Black Locking Knob located on the handle.
8. When case at desired position, lock into place by
pressing down on the fabric tension lock lever.
(When ordering parts, please specify screen model and size.)
Follow steps 1 through 3 above.
a. Raise locking lever on left side of handle.
b. Release black knob and lower case.
c. Holding bottom tube, raise extension tube until
it locks into desired position.
1) Slat
2) Saddle
3) Pull Bail
4) Hanger Hook
5) Picture Surface
6) Extension Tube
7) Black Locking Knob
8) Bottom Tube
9) Handle
10) Roller
11) Tripod
12) Leg Bracket
13) Toe Release &
Leg Lock
14) Leg Shoes
15) Fabric Tension
Lock Lever
16) End Cap
17) Screen Case
18) Black Locking Knob
19) Slat Caps
1
2
3
4
5
6
7
8
9
10
12
13
14
15
16
17
18
19
11
