FOR WALL MOUNTING
HARDWARE PROVIDED
2 – “V” Bars ( one is factory mounted to the
back of the case; one will be mounted to
the wall)
6 – Toggle Bolts, 4"
6 – Lead Shields, #10-14 x 1
1
/
2
"
6 – Phillips Flat Head Wood Screws, #10 x 2"
TOOLS REQUIRED
Electric Drill
Masonry Bit
5
/
16
" (if mounting in solid masonry
or concrete)
Screw Driver, #2 Flat Tip (if using toggle bolts)
or #2 Phillips (if mounting in solid masonry or
concrete)
INSTALLATION INSTRUCTIONS
Determine the height of the top of the case
from the floor. This will be the height of the
wall mounted “V” bar.
Hold the loose “V” bar to the wall at the height
determined above (MAKE SURE IT IS LEVEL),
and mark the location for the screw holes. To
mount the “V” bar on solid concrete or
masonry wall, drill
5
/
16
" holes and insert the lead
shields. Fasten the “V” bar to the wall using
the #10 x 2" wood screws. If you are mounting
to a hollow wall, drill
1
/
2
" holes and insert the
toggle bolts. Then fasten the “V” bar to the
wall with the toggle bolts. Now set the case in
place on the wall with the “V” bar of the case
nestled into the “V” bar on the wall.
FOR CEILING SUSPENSION
Position and properly anchor screw hooks into
ceiling, beam or other solid surface. Then
proceed to use the two “D” rings that are
factory mounted to the top of the case to hang
the case securely.
TO LOWER AND RAISE PICTURE SURFACE
To lower the picture surface, pull the screen
down all the way. Then hesitate and allow the
screen to retract very slowly until it locks in
place. To raise the picture surface pull down on
the pull bail, then raise quickly, as a window
shade. Keep control of the picture surface. Do
not allow it to roll uncontrolled into the case or
damage to the screen is sure to result.
Allow a minimum of
1
1
/
4
" from the ceiling
Ceiling
4
1
/
4
"
4"
Determine
measurement to the
top of the Case
Wall
“V” Bar mounted
to the back of the
Case at the factory
“V” Bar mounted
to the wall
Mount top of
“V” Bar flush
with top of Case
Floor line
