background image

2

HooK MounT 

HoLE

SET SCREWS (2)

FIGURE 3

INSTALLATION

Ceiling Hook

  1.  Do not remove the wall mount bracket, even if 

you are not using it for mounting. This provides 
structural stability to the case.

  2.  Be sure the ceiling has adequate reinforcement to 

attach a hook anchor.

  3.  The top of the screen case has a channel that the 

ceiling hook brackets slide into. The brackets can 
be attached anywhere within 12" of the end of the 
case. Loosen the set screws on the brackets and 
slide the brackets to the desired location. Lock the 
brackets in place by tightening two set screws. 
Refer to figure 3.

  4.  attach an S-hook or similar fastener to the large 

center hole on the bracket.

OPERATING INSTRUCTIONS

TO LOWER PICTURE SURFACE

Pull screen down all the way. HESiTaTE – then allow screen to retract VERY SLoWLY until it locks in place.

TO RAISE PICTURE SURFACE

Pull down on the pull bail, then release quickly. The screen will retract gently into the case.

TO ADJUST RETRACTION SPEED

use a large flat screwdriver to turn the adjustment knob on the right end of the screen (see figure 2 or 3). To increase the 
travel speed turn counterclockwise. To decrease the travel speed turn clockwise. adjustments should be made in half 
turn increments and travel speed checked before adjusting further.

If screen locks at the bottom and will not retract, turn adjustment knob one quarter turn counterclockwise.

SCREEN ACCESSORIES

No. 23 ADJUSTABLE

WALL BRACKETS

Screen can be extended 10", 

14", 15

3

4

", 18

1

4

", 20" or 24" 

from wall by wing nut and bolt 

adjustment.

No. 11 WALL BRACKETS

Screen can be extended 10" 

or 14" from wall by changing 

position of bracket.

No. 6 WALL BRACKETS

Screen can be extended 6" 

from wall. 

WALL BRACKETS - (75# per pair maximum)

Da-Lite no. 6 and no. 11 non-adjustable wall brackets 

and no. 23 adjustable extension wall brackets are ideal 

for keystone elimination, clearance, or corner mounting. 

The screen brackets should be fastened to the studding 

or other solid surface and not in the plaster only. 

T-BAR CLIP

For Dropped Ceilings

50 lb. max. load capacity.

TILT LOCK

For Keystone Elimination

Holds back bottom of

screen in tilted position

to eliminate keystoning.

S-HooK

T-BaR CLiP

CEiLing

Summary of Contents for DesIgner Contour Manual

Page 1: ...troit Street Post Office Box 137 Warsaw Indiana 46581 0137 Phone 574 267 8101 800 622 3737 Fax 574 267 7804 Toll Free Fax 877 325 4832 www da lite com e mail info da lite com Instruction Book for Designer Contour Manual The Da Lite Difference ...

Page 2: ...screws on the brackets and slide bracket so it extends over the end of the case Lock the brackets in place by tightening two set screws Refer to figure 2 Mount cannot be more than 12 from end of case 4 Hold the screen case up to the ceiling and mark the hole locations Drill holes into the ceiling and attach screen with the appropriate fasteners for your ceiling SET SCREWs 2 ceiling mount holes FIG...

Page 3: ...at screwdriver to turn the adjustment knob on the right end of the screen see figure 2 or 3 To increase the travel speed turn counterclockwise To decrease the travel speed turn clockwise Adjustments should be made in half turn increments and travel speed checked before adjusting further If screen locks at the bottom and will not retract turn adjustment knob one quarter turn counterclockwise SCREEN...

Page 4: ...to your Da Lite dealer If it is necessary for the dealer to return the screen or part to Da Lite transportation expenses to and from Da Lite are payable by the purchaser and Da Lite is not responsible for damage in shipment To protect yourself against damage or loss in transit insure the product and prepay all transportation expenses THIS WARRANTY IS IN LIEU OF ALL OTHER WARRANTIES EXPRESS OR IMPL...

Reviews: